HowmetHowmet
Nominal Diameter |
N/A 05 |
A Head |
N/A 0.272 in |
B Height |
N/A 0.070 in |
C Min |
N/A 0.844 in |
D |
N/A 0.163 in |
E Max |
N/A 0.215 in |
R Rad Max |
N/A 0.010 in |
S Design Ref Only |
N/A 0.232 in |
Design Grip Range Min. - Max. |
N/A 0.093 - 0.157 |
Single Shear Strength |
N/A 1980 lb |
Tensile Strength |
N/A 900 lb |
Hole Diameter |
N/A 0.164 in |
Grip Dash No. |
N/A 02 |
Overlap Grip Max |
N/A 0.173 in |
Design Grip Range Min. |
N/A 0.093 in |
Design Grip Range Max. |
N/A 0.157 in |
Finish Code |
N/A W |
Notes |
N/A
1. Diameter "D" may be .0005" oversize for coated parts. 2. Applies to grips 04-02 Max, 05-03 Max, 06-03 Max, 08-04 Max, and 10-05 Max and greater. In shorter grips, a true composite shear test cannot be performed. 3. Trim flash not to exceed .005 maximum length above head of pin. 4. Solid or split lock collar at manufacturer´s option. Split not to exceed .020 width. 5. Knurled to retain fastener assembly. Not part of installed fastener. 6. Blind side head may be installed on 7° max slope 7. Identification: Huck symbol, MV (for CP titanium sleeve material) and grip dash number. 8. The average reading of the smallest & largest observed value on the same specimen must be equal to or greater than the stated minimum diameter. This is applicable to design grip range. 9. Sleeve diameter "D" may be .001" undersize in this area. 10. Optional drive washer for installation with blunt tool. Not part of installed fastener. 11. Overlap in design grip range makes fastener well-suited for composite structures with large grip tolerances. Fastener is intended to be installed in "design grip range". Fasteners installed in grips above "design grip range" perform reliably provided that the installed pin and collar flushness requirements are met. 12. Lube and lock collar material at manufacturer´s option. |
