close
close
Ti-Matic® Blind Bolt Fastener, High Strength, Pull-Type, Positive Mechanical Lock, MS20470 Style Protruding Head
Unit of Measure

Nominal Diameter

N/A 06

Design Grip Range Min. - Max.

N/A 0.344 - 0.407

A Head

N/A 0.391 in

B Head Height

N/A 0.089 in

C Min

N/A 0.875 in

D

N/A 0.198 in

E Max

N/A 0.250 in

R Rad Max

N/A 0.015 in

(S) Design Ref Only

N/A 0.292 in

Z Min.

N/A 0.275 in

Min. Single Shear Strength

N/A 2925 lb

Min. Tensile Strength

N/A 1400 lb

Hole Size

N/A 0.199 in

Overlap Grip Max

N/A 0.423 in

Design Grip Range Min.

N/A 0.344 in

Design Grip Range Max.

N/A 0.407 in

Finish Code

N/A None

Sleeve Material

N/A CP titanium per chemistry of ASTM B348 Grade 1

Pin Material

N/A 38-6-44 titanium per chemistry of SAE-AMS4957 or SAE-AMS-T-9047

Lock Collar Material

N/A A-286 per chemistry of SAE-AMS5737 or TYPE 316 cres per chemistry of SAE-AMS5690

Sleeve Finish

N/A None

Pin Finish

N/A None

Lock Collar Finish

N/A Passivate per SAE-AMS2700 Type 2 or Type 8

Sleeve Lube

N/A None or cetyl alcohol per SAE-AS87132 or dry film lube per SAE-AS5272 Type 1

Pin Lube

N/A None or cetyl alcohol per SAE-AS87132 or dry film lube per SAE-AS5272 Type 1

Lock Collar Lube

N/A Dicronite DL-5 lube per DOD-L-85645

Grip Dash No.

N/A 06

N/A 1. Diameter "D" may be up .0005" oversize for coated parts.
2. Applies to grips 04-02 max, 05-03 max, .06-.03 max, 08-04 max, and 10-05 max and greater. In shorter grips, a true composite shear test cannot be performed. 3. Trim flash not to exceed .005 maximum length above head of pin.
4. Solid or split lock collar at manufacturer´s option. Split not to exceed .020 width.
5. Knurled to retain fastener assembly. Not part of installed fastener.
6. Blind side head may be installed on 7° max slope.
7. Identification: Huck symbol, MV (for CP titanium sleeve material) and grip dash number.
8. The average reading of the smallest & largest observed value on the same specimen must be equal to or greater than the stated minimum diameter. This is applicable to design grip range.
9. Sleeve diameter "D" may be .001" undersize in this area.
10. Optional drive washer for installation with blunt tool. Not part of installed fastener.
11. Overlap in design grip range makes fastener well-suited for composite structures with large grip tolerances. Fastener is intended to be installed in "design grip range". Fasteners installed in grips above "design grip range" parform reliably provided that the installed pin and collar flushness requirements are met.
12. Lube and lock collar at manufacturer´s option.