close
close
Ti-Matic® Blind Bolt Fastener, High Strength, Pull-Type, Positive Mechanical Lock, Protruding Head
Unit of Measure

Nominal Diameter

N/A 06

Design Grip Range Min. - Max.

N/A 0.344 - 0.407

A Head

N/A 0.332 in

B Head Height

N/A 0.135 in

C Min

N/A 0.875 in

D

N/A 0.198 in

E Max

N/A 0.250 in

R Rad Max

N/A 0.015 in

S Design Ref Only

N/A 0.292 in

Single Shear Strength

N/A 2925 lb

Tensile Strength

N/A 1690 lb

Hole Size

N/A 0.199 in

Grip Dash No.

N/A 06

Overlap Grip Max

N/A 0.422 in

Finish Code

N/A AC

Sleeve Material

N/A A-286 per chemistry of SAE-AMS5737

Pin Material

N/A 38-6-44 titanium per chemistry of SAE-AMS4957 or SAE-AMS-T-9047

Lock Collar Material

N/A A-286 per chemistry of SAE-AMS5737 or TYPE 316 cres per chemistry of SAE-AMS5690

Sleeve Finish

N/A Aluminum coat per NAS4006

Pin Finish

N/A None

Lock Collar Finish

N/A Passivate per SAE-AMS2700 Type 2 or Type 8

Sleeve Lube

N/A None or cetyl alcohol per SAE-AS87132 or dry film lube per SAE-AS5272 Type 1

Pin Lube

N/A None or cetyl alcohol per SAE-AS87132 or dry film lube per SAE-AS5272 Type 1

Lock Collar Lube

N/A Dicronite DL-5 lube per DOD-L-85645

N/A 1. Minimum ultimate single shear and tensile strengths, in pounds, of installed fastener.
2. Applies to grips 05-03 Max, 06-03 Max, and 08-04 Max and greater.
3. Trim flash not to exceed .005 maximum length above head of pin.
4. Solid or split lock collar at manufacturer's option. Split not to exceed .020 width. Single action fasteners have a shear cap to facilitate installation. The shear cap is not part of the installed fastener.
5. Knurled to retain fastener assembly. Not part of installed fastener.
6.Blind side head may be installed on 5° maximum slope.
7. Identification: Huck symbol, "EV" and grip dash number.
8. Diameter of pin head shall not exceed "D" Max and may be .002 below "D" Min.
9. Sleeve diameter "D" may be .002 undersize in this area.