close
close
Ti-Matic® Blind Bolt Fastener, High Strength, Pull-Type, Positive Mechanical Lock, 100° Flush Head
Unit of Measure

Nominal Diameter

N/A 08

Design Grip Range Min. - Max.

N/A 0.344 - 0.407

A Head Theo Inter.

N/A 0.508 in

B Head Height

N/A 0.106 in

C Min

N/A 1.000 in

D

N/A 0.259 in

E Max

N/A 0.305 in

F Max

N/A 0.017 in

G Gage

N/A 0.4319 in

H Gage Height

N/A 0.0270-0.0310

R Rad Max

N/A 0.020 in

S Design Ref Only

N/A 0.361 in

Single Shear Strength

N/A 5005 lb

Tensile Strength

N/A 2900 lb

Hole Diameter

N/A 0.260 in

Grip Dash No.

N/A 05

Overlap Grip Max

N/A 0.423 in

Finish Code

N/A AC

Sleeve Material

N/A A-286 per chemistry of SAE-AMS5737

Pin Material

N/A 38-6-44 titanium per chemistry of SAE-AMS4957 or SAE-AMS-T-9047

Lock Collar Material

N/A A-286 per chemistry of SAE-AMS5737 or TYPE 316 cres per chemistry of SAE-AMS5690

Sleeve Finish

N/A Aluminum coat per NAS4006

Pin Finish

N/A None

Lock Collar Finish

N/A Passivate per SAE-AMS2700 Type 2 or Type 8

Sleeve Lube

N/A None or cetyl alcohol per SAE-AS87132 or dry film lube per SAE-AS5272 Type 1

Pin Lube

N/A None or cetyl alcohol per SAE-AS87132 or dry film lube per SAE-AS5272 Type 1

Lock Collar Lube

N/A Dicronite DL-5 lube per DOD-L-85645

N/A 1. Minimum ultimate single shear and tensile strengths, in pounds, of installed fastener.
2. Applies to grips 05-04 Max, 06-05 Max, and 08-06 Max and greater. In shorter grips, a true composite shear test cannot be performed.
3. Trim flash not to exceed .005 maximum length above head of pin.
4. Solid or split lock collar at manufacturer's option. Split not to exceed .020 width. Single action fasteners have a shear cap to facilitate installation. The shear cap is not part of the installed fastener.
5. Knurled to retain fastener assembly. Not part of installed fastener.
6.Blind side head may be installed on 5° maximum slope.
7. Identification: Huck symbol, "EV" and grip dash number.
8. Concentricity: Conical surface of flush head to "D" diameter to be within .010 F.I.M.
9. Diameter of pin head shall not exceed "D" Max and may be .002 below "D" Min.
10. Sleeve diameter "D" may be .002 undersize in this area.
11. The grip range of SB100-EV06-02 is .120-.157