close
close
close
Request Information
Please click here to view the Installation and Removal

Unit of Measure

Insert Type

 N/A Standard

Series

 N/A RJ200

Material Type

 N/A 6AI-4V Titanium

Material Specification

 N/A MIL-T-9047, COND A or AMS4967

Heat Treat

 N/A 130 KSI UTS min

Finish

 N/A None

Military Part Number

 N/A MS51991-205

Lockring Rosan Part Number

 N/A RLRR24SA7

Lockring Military Part Number

 N/A AS51990-105P

Internal Thread Lock

 N/A No
A - Internal Thread, Class 3B1 N/A 0.1900-32 UNJF

B - External Thread

 N/A 0.3125-18

B - External Thread - Pitch Diameter

 N/A 0.2769-0.2789 in

B - External Thread - Minor Diameter

 N/A 0.2373-0.2468 in

C - Overall Length ±.015

 N/A 0.440 in

D - Thread Length ±.015

 N/A 0.290 in

E ±.015

 N/A 0.150 in

F - Dia

 N/A 0.248 in

G - Dia

 N/A 0.237 in

H - Dia

 N/A 0.196-0.206 in

J - Number of Teeth

 N/A 17.000

K +2º -1º

 N/A 86.000 º

L - Diameter +.007 -.002

 N/A 0.284 in

M - Diameter +.005 -.004

 N/A 0.255 in

N ±.015

 N/A 0.090 in
Aluminum Step Drill Part Number2 N/A RCDC24-257
Magnesium Step Drill Part Number3 N/A RCADC24-257
Basic Tap Size4 N/A 0.3125-18 UNC

Wrench Part Number

 N/A R1105W

Lockring Drive Tool Part Number

 N/A R205D
Removal Drill Size5 N/A F

N/A

  • The external thread has a special pitch diameter and minor diameter, which installs into an AS8879 Class 3B, FED-STD-H28/2 Class 3B, or National Class 3 tapped hole.
  • <3> Mating lockring is not included with insert. It must be ordered separately.
  • <4> For standard lenghts as shown in table, "C" overall length and "D" thread length applies. For non-standard lengths, "C" lengths is in 1/16 inch increments and "E" dimension applies in place of "D" dimension.
  • Unless otherwise specified dimensions are in inches & ASME Y14.5M.
  • When parent material surface is not flat or normal to axis of hole, provide a spotface for proper lockring entry.
  • Remove all burrs and sharp edges.
  • 1 AS8879 Internal Thread
  • 2 Step drills are designed for thru hole drilling. When used to drill a blind hole, it may be necessary to grind the drill to suit the depth required.
  • 3 Step drills are designed for thru hole drilling. When used to drill a blind hole, it may be necessary to grind the drill to suit the depth required.
  • 4 Taps are not supplied by Howmet.
  • 5 Removal drills are not supplied by Howmet.