close
close
close
Request Information
Unimatic® Blind Bolt Fastener, High Strength, Pull-Type, Positive Mechanical Lock, Protruding Head, Alloy Steel (112 KSI Shear) Single Action Installation
Unit of Measure

Nominal Size

 N/A 05

A Head Dia.

 N/A 0.250 in0.272 in

B Head Height

 N/A 0.062 in0.070 in

C Min.

 N/A 0.844 in

D Sleeve Dia. ±.001

 N/A 0.163 in

E Max.

 N/A 0.215 in

R Rad. Max.

 N/A 0.010 in

S Design Ref. Only Max.

 N/A 0.202 in

Single Shear1,2

 N/A 2340 lb

Tensile1

 N/A 1350 lb

Hole Limits +.003 / -.000

 N/A 0.164 in

Grip Dash No.

 N/A 11

Design Grip Range Min.

 N/A 0.656 in

Design Grip Range Max.

 N/A 0.720 in

L Ref.

 N/A 0.842 in

M Max.

 N/A 0.996 in

MS part number

 N/A MS90354U0511

Material Sleeve

 N/A Alloy Steel

Material Pin

 N/A 8740 Alloy Steel per ASTM-A-331, ASTM-A-29, or AMS6322

Material Mechanical Lock

 N/A A286 CRES per Chemistry of AMS5737 or 316 CRES for Chemistry of AMS5690 (Manufacturer's Option)

Protective Treatment Sleeve

 N/A Cadmium Plate per QQ-P-416, Type II, Class 2 or Aluminum Coating per MIL-C-83488

Protective Treatment Pin

 N/A Cadmium Plate per QQ-P-416, Type I, Class 3 with Hydrogen Embrittlement Relief per MIL-F-81177 or Aluminum Coating per MIL-C-83488

Lubrication Pin & Sleeve

 N/A None

Lubrication Mechanical Lock

 N/A Passivate per QQ-P-35, A-286 Cres and 316 Cres Only. Lubrication None or Manufacturer's Option to Lubricate Mechanical Lock only with Lox Compatible Dry Film.

N/A

  1. Minimum ultimate single shear and tensile strengths, in pounds, of installed fastener.
  2. Applies to grips 05-03, 06-03, 08-04, 10-05 & 12-06 and up. In shorter grips a true composite shear test cannot be obtained.
  3. Solid or split lock collar - Manufacturer's option. Split not to exceed .020 width.
  4. Knurled to facilitate fastener assembly. Not part of installed fastener.
  5. Maximum diameter of blind head shall not exceed maximum diameter of manufactured head "A". For engineering design ref. only.
  6. Blind side head may be installed on 5° maximum slope.
  7. Trim flash not to exceed .005 maximum length above head of pin.
  8. Nominal size 05 and 06 part numbers are color identified green. (Location optional)
  9. Identification: Manufacturer's options - Huck symbol and grip dash number. Single diget marking is permissible for grip numbers less than 10.
  10. Concentricity: Conical surface of protruding head to "D" diameter to meet requirements of MIL-F-81177.
  11. Diameter of pin head shall not exceed "D" max. and may be .002 below "D" min.
  12. Drive washer available to facilitate installation only. Not part of installed fastener.