close
close
These diameter and grips are available on special order only.
Unit of Measure

Nominal Diameter No.

N/A 6

A - Diameter +.003 -.001

N/A 0.201 in

B - Diameter ± .005

N/A 0.255 in

BK Min

N/A 0.410 in

C ± .010

N/A 0.353 in

D

N/A 0.023 in

E +.010 -.000

N/A 0.040 in

H

N/A 0.940 in

J - Diameter

N/A 0.204 in

S - Diameter

N/A 0.117 in
Tensile1 N/A 710 lb

Installed Spindle Retention

N/A 290

Hole Limits

N/A 0.205-0.209 in

Material Sleeve

N/A 5056 Aluminum per QQ-A-430

Material Spindle

N/A 8740 Alloy Steel per AMS 6322

Material Expander

N/A 1038 Alloy Steel

Material Washer

N/A Alloy Steel

Material Lock Ring

N/A A286 Stainless Steel per AMS 5737

Finish Sleeve

N/A Clear Chromate per MIL-C-5541

Finish Spindle

N/A Cadmium Plate per AMS-QQ-P-416, Type II, Class 2

Finish Expander

N/A Cadmium Plate per AMS-QQ-P-416, Type II, Class 2

Finish Washer

N/A Clear Chromate

Finish Lock Ring

N/A Passivate per AMS-QQ-P-35

Head Style

N/A Unisink

Sleeve Diameter

N/A Oversized

N/A

  • Lubrication: Lubricate per NAS 1686 except on sleeve component. If lubed, restrict to tiolon Y-14 only for maximum paint adhesion properties. Do not clean or degrease prior to installation. Lubricant must not be removed.
  • Rivets covered on tfis standard are intended for use as repair/replacement for nominal rivets of similar application.
  • Spindle configuration - pulling serration dimensions shall be per NAS 9315.
  • <6> Silver color driving anvil identifies oversize rivet.
  • 1 Minimum ultimate shear and tensile strength, in pounds, of installed rivet.
    Applies to grips 4-03 max, 5-03 max, 6-04 max and up.