Howmet
A |
N/A 0.720-0.730 in |
B |
N/A 0.392-0.400 in |
C |
N/A 0.534 in |
D |
N/A 0.483 in |
F |
N/A 0.060 in |
G |
N/A 0.372 in |
L - MAX |
N/A 0.475 in |
M - MAX |
N/A 0.483 in |
X |
N/A 0.104 in |
Drive Tool Dash No. |
N/A -12 |
Axial Tensile Strength lbf Min |
N/A 8700.000 lb |
Thread per AS8879 |
N/A 0.3750-24 UNJF-3B |
Nut Material |
N/A Titanium |
Seal Material |
N/A Teflon per ASTM - D - 1710 |
Nut Heat Treat |
N/A per AMS-H-81200 |
Nut Finish |
N/A Coat outside of nut (Threads & C´bore optional) with dry film lubricant per AS5272, Type 1, plus (optional) cetyl alcohol lubricant. |
Seal Finish |
N/A (optional) cetyl alcohol lubricant. |
Performance |
N/A ENSI1312, Except as follows: A) Free running torque for EN1482ND5 & NDU5 to be 4 ozf-in maximum |
Nominal Stud Nut Size |
N/A 3/8-24 |
Notes |
N/A
1. Dimensions to be met after finish, but before lubrication.
2. Color identification: EN1482ND(*): Nuts are identified with white paint within lobe area as shown. All three lobes shall be completely covered with paint on a minimum of 95% of the lobe area of each part. Overspray permitted on exterior surfaces. EN1482NDU(*): "No paint". 3. All EDDIE-NUTS™ must be installed using an appropriate DELTA-RAD™ EDDIE-BOLT® installation tool. 4. "G" Applies after installation of seal5. Nut assemblies shall be packaged in clear, sealed plastic bags. Each bag shall contain a maximum of 100 nuts per diameter. Each bag shall be marked with "EDDIE-NUTS™", Manufacturer´s complete part number, Manufacturer´s lot number, Manufacturer´s name and "PACK" date. |
