HowmetHowmet
A |
N/A 0.418-0.424 in |
B |
N/A 0.268-0.274 in |
C |
N/A 0.359 in |
D |
N/A 0.323 in |
L - MAX |
N/A 0.340 in |
M - MAX |
N/A 0.323 in |
X |
N/A 0.097 in |
Drive Tool Dash No. |
N/A -8 |
Axial Tensile Strength lbf Min |
N/A 5000.000 lb |
Thread per AS8879 |
N/A 0.2500-28 UNJF-3B |
Material |
N/A Stainless Steel |
Heat Treat |
N/A per AMS-H-6875 |
Finish |
N/A Passivate per AMS2700, coat with dry film lubricant per AS5272, Type 1, plus (optional) cetyl alcohol lubricant. |
Performance |
N/A ENSI312 |
Nominal Stud Nut Size |
N/A 1/4-28 |
Notes |
N/A
1. Dimensions to be met after finish, but before lubrication.
2. Shear rated A286 Corrosion resistant steel EDDIE-NUTS™ are identified with yellow paint within lobe area as shown. All three lobes shall be completely covered with paint on a minimum of 95% of the lobe area of each part. Overspray permitted on exterior surfaces. 3. All EDDIE-NUTS™ must be instelled using an appropriate DELTA-RAD™ EDDIE-BOLT® installation tool. 4. Nuts shall be packaged in clear, sealed plastic bags. Each bag shall contain a maximum of 100 nuts per diameter. Each bag shall be marked with "EDDIE-NUTS™", Manufacturer´s complate part number, Manufacturer´s lot number, Manufacturer´s lot number, Manufacturer´s name and "PACK" date. |
