Item # SFT151-16SU56A, Stud - Ring Locked - SF Series On Howmet Aerospace

Request Information

Unit of Measure

Part Type	N/A Stud
Series	N/A SF
Simplified Material	N/A CRES
Material	N/A A286 CRES
Material Specification	N/A AMS 5731,AMS 5734
Heat Treat	N/A 130 KSI UTS min
Finish	N/A Passivate per QQ-P-35
Military Part Number	N/A MS51989-110-56
Lockring Part Number	N/A RLRR47SA10
Lockring Military Part Number	N/A MS51990-109P
Nut End Type	N/A Undrilled
A Nut End Thread Size	N/A 0.5625-18 UNF-3A
B Stud End Thread Size	N/A 0.6250-11
B Stud End Thread-Pitch Diameter	N/A 0.5674-0.5699 in
B Stud End Thread-Minor Diameter	N/A 0.5028-0.5174 in
C	N/A 16
D ±.015	N/A 0.940 in
E ±.015	N/A 0.720 in
F ±.015	N/A 1.000 in
L ±.015	N/A 3.500 in
L Dash Code No.	N/A 56.000

Notes

N/A

<4>Dimension "L" will be threaded its full lenght when it is "C" dash length or shorter. For nut end lenngth longer than "C" dash length with dimension "L" threaded its full length use "SFT" prefix (Example: SFT101-9SA10A). For nut end length see part number coding.
The stud end thread has a special pitch diameter and minor diameter which installs into a MIL-S-8879 class 3B, FED-STD-H28/2 class 3B, or National class 3 tapped hole.
Studs are installed in accordance with MS51995.
Stud end thread lengths shown are based on installation in 2024-T4 Aluminum and will accommodate tension loads up to the strength of the nut end. If this design criteria is required in parent materials of lower mechanical properties, longer stud end lengths than shown above in column "F" should be specified.
<8>2 max incomplete threads.
Mating lockring is not included with stud. It must be ordered separately.