close
close
THREAD: AS8879
MATERIAL:
  • Nut - 3AL - 2.5V Titanium alloy per AMS6940.
  • Washer - 6AL-4V Titanium alloy per AMS4928 or AMS4967 (UNS R56400).
HEAT TREAT: Nut & Washer - per AMS - H - 81200
FINISH:
  • NUT - Coat Outside of Nut (Threads & C'Bore Optional) with dry film lubricant per AS5272, Type I, plus (Optional) cetyl alcohol luricant.
  • Washer - Dry film lubricant coat per AS5272, Type I, plus (Optional) cetyl alcohol lubricant.
PERFORMANCE: 23MI44
Unit of Measure

Specifications

A

N/A 0.355-0.365 in

B

N/A 0.206-0.212 in

C

N/A 0.275 in

D

N/A 0.242 in

E

N/A 0.257 in

H

N/A 0.085-0.095 in

L - MAX

N/A 0.295 in

M - MAX

N/A 0.242 in

X

N/A 0.092 in

Drive Tool Dash No.

N/A -6

Axial Tensile Strength lbf Min

N/A 2500.000 lb

Thread per AS8879

N/A 0.1900-32 UNJF-3B

Nut Material

N/A Titanium

Washer Material

N/A Titanium

Nut Heat Treat

N/A per AMS-H-81200

Washer Heat Treat

N/A per AMS-H-81200

Nut Finish

N/A Coat outside of nut (Threads & C´bore optional) with dry film lubricant per AMS5272, Type 1, plus (optional) cetyl alcohol lubricant.

Washer Finish

N/A Dry film lubricant coat per AMS5272, Type 1, plus (optional) cetyl alcohol lubricant.

Performance

N/A 23MI44

Nominal Stud Nut Size

N/A 10-32

Notes

Notes

N/A 1. Misalignment: For use on sloped surfaces up to 7° maximum, when mated with appropriate EDDIE-BOLT® 2 PIN.
2. Dimensions to be met after finish, but before lubrication.
3. Shear rated 3AL-2.5V Titanium EDDIE-NUTS™ are identified with white paint within lobe area as shown. All three lobes shall be completely covered with paint on a minimum of 95% of the lobe area of each part. Overspray permitted on exterior surfaces.
4. All EDDIE-NUTS™ must be installed using an appropriate DELTA-RAD™ EDDIE-BOLT® installation tool.
5. Nut and Washer are supplied in assembled condition.
6. Nuts shall be packaged in accordance with MAC3112, Table 11.