Nominal Diameter |
N/A 06 |
A Head Dia. |
N/A 0.332 in |
B Head Height |
N/A 0.135 in |
C Min. |
N/A 0.875 in |
D |
N/A 0.198 in |
E |
N/A 0.250 in |
R |
N/A 0.015 in |
S |
N/A 0.231 in |
Design Grip Range Min. - Max. |
N/A 0.781 - 0.845 in |
Single Shear Strength |
N/A 2925 lb |
Tensile Strength |
N/A 1690 lb |
Hole Size |
N/A 0.199 in |
Grip Dash No. |
N/A 13 |
Overlap Grip Max |
N/A 0.860 in |
Design Grip Range Min. |
N/A 0.781 in |
Design Grip Range Max. |
N/A 0.845 in |
Installed Weight |
N/A 9.13 lb |
Finish Code |
N/A None |
Sleeve Material |
N/A A-286 per chemistry of AMS5737 |
Pin Material |
N/A 38-6-44 titanium per chemistry of AMS4957 or AMS-T-9047 |
Lock Collar Material |
N/A A-286 per chemistry of AMS5737 or type 316 cres per chemistry of AMS5690 |
Sleeve Finish |
N/A Passivate per AMS2700 |
Pin Finish |
N/A None |
Lock Collar Finish |
N/A Passivate per AMS2700 |
Sleeve Lube |
N/A None or cetyl alcohol per AS87132 or dry film lube per AS5272 Type 1 |
Pin Lube |
N/A None or cetyl alcohol per AS87132 or dry film lube per AS5272 Type 1 |
Lock Collar Lube |
N/A Dicronite DL-5 lube per DOD-L-85645 |
Notes |
N/A
1. Minimum ultimate single shear and tensile strength, in pounds, of installed fastener. 2. Applies to grips 05-03 Max, 06-03 Max, 10-05 Max and greater. In shorter grips, a true composite shear test cannot be performed. 3. Trim flash not to exceed .005 maximum length above head of pin. 4. Solid or split lock collar at manufacturer´s option. Split not to exceed .020. 5. Knurled to retain fastener components. Not part of installed fastener. 6. Blind side head may be installed on 5° max slope. 7. Identification: Huck symbol, EV and grip dash number. 8. The average reading of the smallest & largest observed value on the same specimen must be equal to or greater than the stated minimum diameter. This is applicable to design grip range. 9. Concentracity: Conical surface of protruding head to "D" diameter to be within .010 F.I.M. 10. Optional drive washer for installation with blunt nosed tool. Not part of installed fastener. 11. "E" length of diameter "D" may be .002 undersized. 12. Diameter of pin head shall not exceed "D" max and may be .002 below "D" min. 13. Overlap in design grip range makes fastener well-suited for composite structures with large grip tollerances. Fastener is intended to be installed to be installed in "design grip range". Fasteners installed in grips above "design grip range" perform reliably provided that the installed pin and collar flushness requirements are met. 14. Lube and lock collar material at manufacturer´s option. |