close
close
These diameter and grips are available on special order only.
Unit of Measure

Nominal Diameter No.

N/A 4

A - Diameter +.003 -.001

N/A 0.140 in

B - Diameter ± .005

N/A 0.165 in

BK Min

N/A 0.390 in

C ± .010

N/A 0.220 in

D

N/A 0.011 in

E +.010 -.000

N/A 0.022 in

H

N/A 0.870 in

J - Diameter

N/A 0.143 in

S - Diameter

N/A 0.081 in
Tensile1 N/A 345 lb

Installed Spindle Retention

N/A 150

Hole Limits

N/A 0.143-0.146 in

Material Sleeve

N/A 5056 Aluminum per QQ-A-430

Material Spindle

N/A A286 Stainless Steel per AMS 5737

Material Expander

N/A A286 Stainless Steel AMS 5737 or 300 CRES per ASTM A493

Material Washer

N/A Alloy Steel

Material Lock Ring

N/A A286 Stainless Steel per AMS 5737

Finish Sleeve

N/A Clear Chromate per MIL-C-5541

Finish Spindle

N/A Passivate per AMS-QQ-P-35

Finish Expander

N/A Passivate per AMS-QQ-P-35 or None

Finish Washer

N/A Clear Chromate

Finish Lock Ring

N/A Passivate per AMS-QQ-P-35

Head Style

N/A Unisink

Sleeve Diameter

N/A Oversized

N/A

  • Lubrication: Lubricate per NAS 1686 except on sleeve component. If lubed, restrict to tiolon Y-14 only for maximum paint adhesion properties. Do not clean or degrease prior to installation. Lubricant must not be removed.
  • Rivets covered on tfis standard are intended for use as repair/replacement for nominal rivets of similar application.
  • Spindle configuration - pulling serration dimensions shall be per NAS 9315.
  • <6> Silver color driving anvil identifies oversize rivet.
  • 1 Minimum ultimate shear and tensile strength, in pounds, of installed rivet.
    Applies to grips 4-03 max, 5-03 max, 6-04 max and up.