Howmet
A |
N/A 0.355-0.365 in |
B |
N/A 0.206-0.212 in |
C |
N/A 0.275 in |
D |
N/A 0.242 in |
E |
N/A 0.257 in |
H |
N/A 0.085-0.095 in |
L - MAX |
N/A 0.295 in |
M - MAX |
N/A 0.242 in |
X |
N/A 0.092 in |
Drive Tool Dash No. |
N/A -6 |
Axial Tensile Strength lbf Min |
N/A 2500.000 lb |
Thread per AS8879 |
N/A 0.1900-32 UNJF-3B |
Nut Material |
N/A Titanium |
Washer Material |
N/A Titanium |
Nut Heat Treat |
N/A per AMS-H-81200 |
Washer Heat Treat |
N/A per AMS-H-81200 |
Nut Finish |
N/A Coat outside of nut (Threads & C´bore optional) with dry film lubricant per AS5272, Type 1, plus (optional) cetyl alcohol lubricant. |
Washer Finish |
N/A Dry film lubricant coat per AS5272, Type 1, plus (optional) cetyl alcohol lubricant. |
Performance |
N/A ENSI1312, Except as follows: A) Free running torque EN1382ND-5 & NDU5 to be 4 ozf-in maximum |
Nominal Stud Nut Size |
N/A 10-32 |
Notes |
N/A
1. Misalignment: For use on sloped surfaces up to 7° maximum. When mated with apropriate EDDIE-BOLT® 2 PIN.
2. Dimensions to be met after finish, but before lubrication. 3. Color identification: EN1282ND(*): Nuts are identified with white paint within lobe area as shown. All three lobes shall be completely covered with paint on a minimum of 95% of the lobe area of each part. Overspray permitted on exterior surfaces. EN1382NDU(*): "No paint". 4. All EDDIE-NUTS™ must be installed using an appropriate DELTA-RAD™ EDDIE-BOLT® installation tool. 5. Nut assemblies shall be packaged in clear, sealed plastic bags. Each bag shall contain a maximum of 100 nuts per diameter. Each bag shall be marked with "EDDIE-NUTS™", Manufacturer´s complete part number, Manufacturer´s lot number, Manufacturer´s name and "PACK" date. 6. Nut and Washers to be aligned with low breakage adhesive in the assembled condition. |
